Home
Rifle Loads
Handgun Loads
Webshop
Equipment
Bullet Review
Newsbooth
Reloader's Nest Forum
Reloader's Nest Forum
Home | Profile | Register | Active Topics | Members | Private Messages | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 Reloading General
 General forum
 Potential issues with threading a barrel		  New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

raginbullsht
Average Member



129 Posts
Posted - Nov 06 2009 :  22:25:49  Show Profile Send raginbullsht a Private Message  Reply with Quote
I am looking at the Ruger 10/22 with target crown and spiral finish as a plinker that I can use a suppressor on. Will having the spiral outer finish on the barrel cause issues when threading it?


http://www.ruger-firearms.com/products/1022TargetTactical/index.html
"If we knew what it was we were doing, it would not be called research, would it?"
- Albert Einstein

IraqVet2003
Advanced Member



USA
1206 Posts
Posted - Nov 06 2009 :  22:50:56  Show Profile Send IraqVet2003 a Private Message  Reply with Quote
No you will have to lathe the barrel down and thread it thats about it, also recommend getting a thread protector as well. Vet
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
Reloader's Nest Forum © 2000-08 ReloadersNest Go To Top Of Page
This page was generated in 0.09 seconds. Powered By: Snitz Forums 2000 Version 3.4.06